Changes

These Y-cables for [[Digital Joysticks]] were made by 3rd party vendors as a replacement to the original [[Amstrad JY-1/JY-2 joysticks|JY-2 joystick]] for the Amstrad CPC computers.

In order to push sales of Amstrad's own joysticks, Amstrad designed the CPC with one joystick port only which had two different ground levelscommon signal pins. The idea was to sell one joystick which forwarded the second ground common signal to a built-in joystick port, to which the second joystick could be connected.

== Weblinks Technical ==

== Manual ==Basically, Pin8 needs to be swapped with Pin9 for the second joystick. However, the cable should also contain '''diodes''' in order to prevent conflicts between the two joysticks. For example, if Player 1 moves UP-'''and'''-RIGHT then UP and RIGHT are shortcut with each other. In result, without the diodes, Player 2 would automatically move UP-'''and'''-RIGHT whenever trying to move UP-'''or'''-RIGHT. '''Caution:''' The CPC+ has some kind of built-in Y-cable with only 8 diodes. But, for properly supporting the included 2-button joypads it would require 12 diodes.

[[Joystick Splitter]](an article from an english magazine, describing how to make a Y-cable)

== Examples ==<gallery>Image:Amstrad joysplit.jpg|Y-box with 5 diodes (looks incomplete)Image:Joy-Y.jpg|Joystick Y-cableImage:Joystick.jpg|Schematic with 14 diodes (supports 3 buttons)Image:Js1.jpg|Schematic with 10 diodes (supports 1 button)Image:CPC Plus Joystick Port.gif|CPC Plus with 8 diodes (supports 0 buttons)Image:LindyJoystickYcable.jpg|Y-cable for CPC from Lindy</gallery>[[Category:HardwareInput Device]] [[Category:PeripheralsDIY]]